Hi-g dryer is the most important equipment used in Drilling waste management ( DWM )
Zero waste discharge still remains a bit away after going through the previous four steps, therefore solidification, thermal desorption, cuttings reinjection and biodegradation will be utilized to push towards the goal as the last step. Hi-G dryer: KOSUN Hi-G Dryer can recover water- and oil-based mud in drill cuttings with fluid phase down below 10% and remarkable reduction on waste discharge cost. It is especially good at managing oil-based drill cuttings.
Drilling waste management ( DWM ) is a new industry when environment is getting more important. KOSUN Solids Control is a leading supplier with a complete drilling waste management system including Hi G dryer, vertical cuttings dryer and decanter centrifuge. The Hi-G Dryer has been proved to be extremely effective in recovering the oil-based mud cuttings. It is a kind of shale shaker mainly used for drying the drilled solids. The feeder installed on such hi-g dryer is a little different from normal shale shaker, so as to achieve the best efficiency.
Another major benefit of the Hi-G dryer technology, sometimes overlooked, is the elimination of whole mud losses from the shaker. This historically has ensured that the shakers were never run at their optimum capacity and thus the solids control system efficiency was adversely affected. Incorporating the Hi-G dryer down steam allows the shakers to be run close to maximum capacity without the concern of whole mud losses.